Paramount Die

1306 Continental Drive,
Abingdon, Maryland -
United States (21009-2334)
Tel: +1 410 2724600
Fax: +1 410 2726559
Contact person:

News in detail

Paramount Die answers some interesting questions

Published: - 02/03/2011 Author: Dell'Oro, Management
Paramount Die answers some interesting questions.

If I am a wire drawer, why should I outsource my wire die production? By producing 40,000+ wire dies per week, Paramount has the volume to justify utilization of highly efficient and highly consistent automated production equipment. Put simply, Paramount can produce high quality wire dies for a lower cost than wire companies with slower, more manual equipment. By combining the total usage of all of its customers, Paramount can mass produce individual sizes achieving highly efficient production runs.

If I eliminate internal recutting, what happens when I have a surprise and I need dies in less than 24 hours? By maintaining over 300,000 drawing inserts in inventory, Paramount can ship most standard sizes and reduction angles within 24 hours when required. If less than 24 hour turnaround is sometimes required, maintaining a small inventory of all foreseeable sizes is very practical with inexpensive and easy to organize drawing inserts. Normally an investment of less than $2,000 is all that is required to have complete security.

When should I use pressure dies? Pressure dies should be used in most wire drawing applications using dry lubricants and should generally be used in every pass in the draft. The only exception may be when low lubricant residuals are required for the finished product. In these cases, pressure dies are generally utilized in the beginning of the draft and non-pressure dies are used down stream.
How does the ParaLoc Pressure system differ from conventional two die pressure systems?
The ParaLoc pressure system differs from most pressure die systems in that it can withstand extremely high lubricant pressures without leaking. High lubricant pressures help to increase lubricant residuals and therefore improve performance. Pressure systems which are not completely sealed cannot achieve extreme pressures and often reduce thermal transfer as the leaking lubricant surrounds the die creating an insulating barrier. The ParaLoc system also differs from most systems in that it utilizes carbide inserts instead of cased wire dies.

Will I need to modify by die box to utilize the ParaLoc Pressure system? In almost all applications, no modification is required. ParaLoc holders are offered in a wide range of sizes, work with all types of die box cooling and are available in both straight and tapered OD styles. For direct water cooled die boxes, holders are available with O'ring seals as well as with cooling fins for better thermal transfer.

Can I utilize carbide inserts if I don't want to utilize a pressure system? Yes, approximately 30% of Paramount's inserts are utilized in non-pressure applications. Many non-pressure holder types are available fitting all die box dimensions. The most basic holder types come in the same basic dimensions of standard cased drawing dies and utilize the inserts taper to hold it in place in the casing. Other non-pressure holders are available with locking caps to keep the insert from backing out of the holder if excessive back tension is a problem on the drawing machine. For further information, please visit Paramount Die's online stand and/or contact the company.